Investigation to meet China II emission legislation for marine diesel engine with diesel methanol compound combustion technology

In order to reduce the pollutant emission and alleviate the pressure of petroleum resources shortage and greenhouse gas emission at the same time, the use of clean and renewable alternative fuel for marine engines is a promising option. In this study, a marine diesel engine, which was modified to run in diesel methanol compound combustion (DMCC) mode, was investigated. After the diesel injection parameters were calibrated, and combined with a sample after-treatment device DOC (diesel oxidation catalyst), the engine could meet the requirements of China II legislation. The overall MSP (methanol substitute percent) reached 54.1%. The value of each pollutant emission was much lower than that in China II emission legislation, and there was almost no methanol and formaldehyde emissions. When methanol was injected into the inlet manifold, the intake air temperature decreased a lot, as well as the exhaust gas temperature, which were beneficial to increase engine thermal efficiency and improve engine room environment. Compared with the engine running in pure diesel mode, when the engine ran in diesel/methanol dual fuel mode, the combustion phase was advanced, and the combustion duration became shorter. Therefore, the engine thermal efficiency increased, and fuel consumption decreased significantly.     

海绵城市地块汇水区颗粒污染物的传输

目前我国海绵工程建设多集中在地块汇水区单元内开展,通过多个低影响开发(LID)设施协同完成地表径流水质水量的调控,但基于地块汇水区尺度下城市面源污染的产生和控制效果鲜有报道.本研究比较分析了不同硬化率地块汇水单元内的面源颗粒污染物晴天累积、降雨冲刷、地表径流及径流输出负荷状况.结果表明,地块汇水单元内硬质路面是面源颗粒污染物贡献的最主要的下垫面类型,中硬化率(61.1%)地块和高硬化率(73.6%)地块路面街尘累积量分别约占汇水区单元的88.4%(2.22～12.51 g·m~(-2))和90.1%(4.99～33.43 g·m~(-2)),对径流SS的输出贡献比率分别约为91.7%(0.97～7.34 g·m~(-2))和90.5%(0.92～18.77 g·m~(-2)),降雨径流SS污染负荷占比分别约为95.2%和83.1%,经LID设施处理后输出径流污染负荷约为地表径流的24.0%和40.2%.硬质路面的街尘晴天累积及降雨冲刷以150μm为主,地表径流及输出径流则以50μm粒径段为主,同时地块不透水比例的增加,细粒径(105μm)颗粒物的累积及冲刷分布增大(24.4%和106.4%),而粒径50μm的颗粒物在路面径流中的分布减小(12.4%).屋面的街尘累积、冲刷及降雨径流的粒径分布状况与硬质路面大致相似,但中硬化率地块(1 000μm)和高硬化率地块(250～450μm、45μm)在3个粒径段范围的颗粒物累积和冲刷相较于路面街尘粒径分布明显增加(1 000μm:58.1%和108.5%; 250～450μm:72.9%和41.8%;45μm:59.2%和64.8%).以上结果揭示了颗粒污染物在地块汇水区尺度下的污染全过程(累积-冲刷-输出)分布及LID设施对地块整体SS污染负荷的控制效果,可为地块汇水单元内LID设施工程绩效的科学评估提供重要参考.     

A novel state-of-charge-based method for plug-in hybrid vehicle electric distance analysis validated with actual driving data

Mitigation and Adaptation Strategies for Global Change - Promoting Plug-In Hybrid Vehicles (PHEVs) is viewed as a promising strategy to mitigate the energy consumption and greenhouse gas...     

Well-to-wheels greenhouse gas and air pollutant emissions from battery electric vehicles in China

Mitigation and Adaptation Strategies for Global Change - Electric vehicles (EVs) play a crucial role in addressing climate change and urban air quality concerns. China has emerged as the global...     

Optimal range of plug-in electric vehicles in Beijing and Shanghai

Both China’s national subsidy policies for plug-in electric vehicles (PEVs) purchasers and passenger cars corporate average fuel consumption and new vehicle credit regulation (dual-credit policy) favor long-range 300+ km battery electric vehicles (BEVs) and 80+ km plug-in hybrid electric vehicles (PHEVs). However, these electric vehicles tend to have lower energy efficiency and higher purchase and operation costs. Vehicle with larger batteries can also be less equitable because the subsidies are often provided to more expensive vehicles and wealthier owners. This study takes advantage of a novel dataset of daily driving data from 39,854 conventional gasoline vehicles in Beijing and 4999 PHEVs in Shanghai to determine the optimal range of BEVs and PHEVs within their respective cities. We simulate a model to explore ranges with which PEVs emit less GHGs than that of a baseline hybrid and conventional gasoline vehicle while ensuring that all daily travel demands are met. Our findings indicate that in both cities, the optimal ranges to balance cost and travel demand for BEVs are 350 km or less and for PHEVs are 60 km or less in Beijing and 80 km or less in Shanghai. We also find that to minimize carbon dioxide (CO₂) emissions, the ranges are even lower 10 km in Beijing and 30 km in Shanghai. Our study suggests that instead of encouraging long-range PEVs, governments should subsidize PEV models with shorter ranges. Parallel efforts should also be made to both increase renewable energy over fossil fuels and expand charging facilities. Although individual mobility demand varies, the government could reduce occasional long-distance driving by subsidizing alternative transportation choices. Providing week-long driving trials to consumers before their purchases may help decrease the demand of very long range PEVs by alleviating the range anxiety through a learning process.

     

新型Fe3O4@α-MnO2活化过一硫酸盐降解水中偶氮染料

采用两步水热法制备了新型磁性纳米Fe₃O₄@α-MnO₂复合材料作为催化剂,用于活化过一硫酸盐（PMS）产生强氧化性的硫酸根自由基（SO₄^-·）氧化降解偶氮染料活性黑5（RBK5）.采用透射电子显微镜（TEM）,X射线粉末衍射仪（XRD）和振动样品磁强计（VSM）对制备的催化剂进行表征,证明成功合成了纳米α-MnO₂包覆Fe₃O₄形态的Fe₃O₄@α-MnO₂催化剂,催化剂的饱和磁化强度为39.89emu/g.Fe₃O₄@α-MnO₂催化剂活化PMS与单一的Fe₃O₄和α-MnO₂活化PMS相比,具有更高的催化效率,说明铁锰双金属存在协同作用.同时研究了催化剂的投加量、PMS的浓度和初始pH值等各种因素对RBK5的降解效率以及反应动力学的影响.实验结果表明,Fe₃O₄@α-MnO₂催化剂活化PMS降解RBK5的过程符合准一级反应动力学,在催化剂投加量为1.2g/L,PMS的浓度为4mmol/L,初始pH值为7.0,反应时间为60min的情况下,浓度为30mg/L的RBK5的降解效率可达到91%,此时RBK5的降解速率常数也达到最高值0.023min^-1.此外,通过加入自由基淬灭剂甲醇、叔丁醇和硝基苯判断了Fe₃O₄@α-MnO₂/PMS体系中起主要氧化降解作用的活性物种为SO₄^-·.     

The effects of autophagy on vascular endothelial cells induced by airborne PM2.5

The purpose of this study was to examine the direct toxicity of PM2.5 collected from Beijing on human umbilical vein endothelial cells(HUVEC). A Cell Counting Kit 8(CCK8) assay demonstrated that PM2.5 exposure decreased the proliferation of HUVECs in a dosedependent manner. We also found that PM2.5 exposure induced autophagy in HUVECs, as evidenced by:(1) an increased number of double-membrane vesicles;(2) enhanced conversion and punctuation of the microtubule-associated protein light chain 3(LC3); and(3) decreased levels of the selective autophagy substrate p62 in a time-dependent manner.Furthermore, promoting autophagy in PM2.5-exposed HUVECs with rapamycin increased the cell survival rate, whereas inhibiting autophagy via 3-methyladenine significantly decreased cell survival. These results demonstrate that PM2.5 exposure can induce cytotoxicity and autophagy in HUVECs and that autophagy play a protective role against PM2.5-induced cytotoxicity. The findings of the present study imply a direct toxic effect of PM2.5 on HUVECs and provide novel insight into the mechanism of cardiovascular diseases caused by PM2.5 exposure.     

Effect of TiO2 nanoparticle aggregation on marine microalgae Isochrysis galbana

TiO_2 nanoparticles(NPs) could adversely impact aquatic ecosystems. However, the aggregation of these NPs could attenuate this effect. In this work, the biological effects of TiO_2 NPs on a marine microalgae Isochrysis galbana were investigated. The aggregation kinetics of TiO_2 NPs under different conditions was also investigated to determine and understand these effects. Results showed that, though TiO_2 NPs had no obvious impact on the size and reproducibility of algal cells under testing conditions, they caused a negative effect on algal chlorophyll, which led to a reduction in photosynthesis. Furthermore, fast aggregation of TiO_2 NPs occurred under all conditions, especially at the pH close to the p Hzpc. Increasing ionic strength and NP concentration also enhanced the aggregation rate.The aggregation and the following sedimentation of TiO_2 NPs reduced their adverse effects on I. galbana.     

Mercury flows in large-scale gold production and implications for Hg pollution control

Large-scale gold production(LSGP) is one of the five convention-related atmospheric mercury(Hg) emission sources in the Minamata Convention on Mercury. However, field experiments on Hg flows of the whole process of LSGP are limited. To identify the atmospheric Hg emission points and understand Hg emission characteristics of LSGP, Hg flows in two gold smelters were studied. Overall atmospheric Hg emissions accounted for 10%–17% of total Hg outputs and the Hg emission factors for all processes were 7.6–9.6 kg/ton. There were three dominant atmospheric Hg emission points in the studied gold smelters, including the exhaust gas of the roasting process, exhaust gas from the environmental fog collection stack and exhaust gas from the converter of the refining process. Atmospheric Hg emissions from the roasting process only accounted for 16%–29% of total emissions and the rest were emitted from the refining process. The overall Hg speciation profile(gaseous elemental Hg/gaseous oxidized Hg/particulate-bound Hg) for LSGP was 34.1/57.1/8.8. The dominant Hg output byproducts included waste acid, sulfuric acid and cyanide leaching residue. Total Hg outputs from these three byproducts were 80% in smelter A and 84% in smelter B. Our study indicated that previous atmospheric Hg emissions from large-scale gold production might have been overestimated.Hg emission control in LSGP is not especially urgent in China compared to other significant emission sources(e.g., cement plants). Instead, LSGP is a potential Hg release source due to the high Hg output proportions to acid and sludge.     

Effects of Na+ on Cu/SAPO-34 for ammonia selective catalytic reduction

Copper-exchanged chabazite (Cu/CHA) catalysts have been found to be affected by alkali metal and alkaline earth ions. However, the effects of Na⁺ ions on Cu/SAPO-34 for ammonia selective catalytic reduction (NH₃-SCR) are still unclear. In order to investigate the mechanism, five samples with various Na contents were synthesized and characterized. It was observed that the introduced Na⁺ ion-exchanges with H⁺ and Cu^2 + of Cu/SAPO-34. The exchange of H⁺ is easier than that of isolated Cu^2 +. The exchanged Cu^2 + ions aggregate and form “CuAl₂O₄-like” species. The NH₃-SCR activity of Cu/SAPO-34 decreases with increasing Na content, and the loss of isolated Cu^2 + and acid sites is responsible for the activity loss.